Description

Product Description

10D UV Glue Tempered Glass For Samsung Galaxy S10 PLUS S10+ fingerprint unlock UV glass Full Cover for S10 S10e Screen Protector

there is a video of how to install this protector,please watch it before install the protector(it is very important)

the transparent glass is case friendly style(There is about 2mm gaps at the edges),can’t cover the whole screen, please pay attention to it

1.Feature (1): Anti-scratch, 3D edge HD, Anti-explosion

2.Feature (2): Anti-fingerprint oil coating,avoid spots and reduce the fingerprints on your screen

3.Surface Hardness: 9H

4.Thickness: 0.2mm

5.Nanoscale optical adhesives are fully adsorbed

6.The whole set contains: 1PCS tempered glass, 1PCS UV lamp , 1PCS liquid glue , 1PCS foil accessory.

Installation steps and precautions:

1. Use a foil cleaning kit to wipe the phone to be clean.
2 .Place the sticker over the hole in the handset. Stick the key hole with a label.
3 .Place custom glue drops on flat, clean and dust-free glass screens. Use each glue to use. It is recommended that the glue be poured completely. The excess glue can be wiped clean before turning on the lights. The glue can only be a mass and cannot be separated. Drops on the screen.
4 .The glue that drops on the screen can\’t have air bubbles, if there is air bubble, use the needle to pierce the air bubble to let go air.
5 .Remove the release film from the protective film and place the glass on the screen so that the glass contacts the glue and gently translate the glass to a suitable position. Do not lift the glass and allow the glass to separate from the glue (very important).
6 .Wait for about 30 seconds to let the glue slowly spread and level.
7. There is glue overflow, wipe off with a clean cloth. After checking the retention criteria for the mobile phone\’s tempered film, the lamp was turned back and forth three times around the edge of the phone, and after 3 seconds of initial curing (not in the middle), the edge glue was wiped again until the glue overflowed. (Prevent white edges or long bubbles on edges)
8. Wait for the exhaust to complete, after the glue overflows cleanly, after the positioning standard of the tempered film is satisfied, turn on the light. Otherwise scrapped material.
9. Irradiate the mobile phone under UV light and need to illuminate twice for about 60 seconds to reach the fully-cured position.

Reviews

There are no reviews yet.

Be the first to review “Samsung S8plus 10D Full Glue Shutter Glass”

Your email address will not be published. Required fields are marked *